MBRP Catback install *question*

[Deeepsix]

Hey everyone, lucked out and my back-ordered MBRP exhaust showed up today. I’m very “mechanically inclined” but was looking for advice on the install. I don’t have access to a lift but have jack stands/can lift the back end of the car in the garage no problem. From the homework I’ve done it looks pretty simple - remove the little brace and then a handful of bolts/studs.

Has anyone done this at home? Trying to gauge if it’s worth it or just pay someone to swap it but knowing how simple it is and knowing I have a toolbox full of tools collecting dust I’d much rather do it myself.

Any insight and/or tips and tricks are appreciated. Can’t wait to hear it with the new exhaust!

Thanks

 

[spider55]

It's a lot easier with a lift, some of the bolts are a pain in the ass to get to. Just make sure you tighten from the front to the rear.

It's easier with two people....

 

[Deeepsix]

Thanks. I figured the two people part may be the bigger issue vs the lift...I’ll make some calls. Thanks for the reply