1/4 mile outing with the LAP3...!

[STINGER]

UPDATE - Stinger went to the strip again today and managed another 12.17 run with the same setup as the 12.16 run, took a video this time

https://www.instagram.com/p/Bgg7fMNAlJT/?taken-by=kiabahrain

 

[VegasStinger]

UPDATE - Stinger went to the strip again today and managed another 12.17 run with the same setup as the 12.16 run, took a video this time

https://www.instagram.com/p/Bgg7fMNAlJT/?taken-by=kiabahrain

Impressive!

 

[turboit]

UPDATE - Stinger went to the strip again today and managed another 12.17 run with the same setup as the 12.16 run, took a video this time

https://www.instagram.com/p/Bgg7fMNAlJT/?taken-by=kiabahrain

Perfect launch

 

[Miguelawd]

So am running the m45il gab to 29 what they came from hks. Still breaking up you think gaping to 24 will fix that? Running lap3 on 93 set up muffler delete

 

[STINGER]

So am running the m45il gab to 29 what they came from hks. Still breaking up you think gaping to 24 will fix that? Running lap3 on 93 set up muffler delete

Could be, you need to narrow down your problem. Are you still breaking up with the LAP3 of the car? if so that means you most likely have a coil issue that needs to be solved first, if not then you need to re-gap to .22-.24 and try again.

 

[KLR STINGER]

So am running the m45il gab to 29 what they came from hks. Still breaking up you think gaping to 24 will fix that? Running lap3 on 93 set up muffler delete

I've seen an 0.28 down to .024 make a difference on other motors. I would gap them down and try again. Also the 45il's are the equivalent of an NGK heat range 9. That's too cold in my opinion. I'd run the 40il's or stock gapped down to .022-24.

 

[sciprox]

So am running the m45il gab to 29 what they came from hks. Still breaking up you think gaping to 24 will fix that? Running lap3 on 93 set up muffler delete

Hey bro, if your misfire continues you might have a bad coil. I ran the JB4 for a few days and had a coil failure. Currently my car is at the dealer waiting on a replacement part.

 

[Miguelawd]

Ok I ran it with out the chip and ran fine that?s why am gonna try the .24 gapping next

 

[sciprox]

Ok I ran it with out the chip and ran fine that?s why am gonna try the .24 gapping next

Awesome hopefully that works out.

 

[KamikazeGT]

Ok I ran it with out the chip and ran fine that?s why am gonna try the .24 gapping next

Did you get a chance to re-gap it?

 

[Miguelawd]

Not yet haven?t had time just haven?t been beating on it lol will post as soon as I do gap and see if that?s fix the problem

 

[KamikazeGT]

Not yet haven?t had time just haven?t been beating on it lol will post as soon as I do gap and see if that?s fix the problem

Thanks